How To Find A Leak In A Pool Liner Above Ground. Adjust the water level in the bucket to be level with the pool. Run your hand from top to bottom.
Observe the direction of the flow of the dye in the water. The region around your above ground pool may signal where the leakage is happening. The suction system and the pressurized system.
Wet Ground In One Area Outside The Pool Will Often Be Leaking Within Just A Few Feet Of The Wet Ground.
It was a pain to find it, but eventually i did and patched it underwater (no need to drain the pool) and all is well. Mark the water level of the pool at the skimmer. See if there’s any pile below the pump and remove if there’s any from the area.
Before You Call A Professional, Here’s What You Look For:
Run your hand from top to bottom. If the dye seems to be stationary, it means you likely have the wrong area. How to locate the leak in your pool.
This Next Step Will Involve Using Food Coloring.
The bad news is, locating a leak in an above ground pool is extremely difficult. If you have a leak anywhere in the pool, the water level inside the bucket will be at a level higher than that of the pool’s water. First off walk around the pool during a good stretch of dry weather and look for wet spots around the circumference of the pool.
Leave The Bucket Alone For Anywhere Between 3 To 7 Days And Do Not Top Off The Water, Checking Regularly To Look For A Change.
Observe the direction of the flow of the dye in the water. Then turn off the pool pump and let the water get completely still. There are two main ways to detect a pool leak.
When Using Dye To Find A Pool Liner Leak, You Will Have To Slowly Squirt The Dye Close To The Liner.
Adjust the water level in the bucket to be level with the pool. Next, take a slow walk around all sides of your pool. That means you must check the plumbing systems, filtration systems, around light housings and the pool pump for signs of leaks.