How To Reset Maintenance Light On Toyota Tacoma 2013

How To Reset Maintenance Light On Toyota Tacoma 2013. If the tacoma has been driven 5,000 miles since the light was reset, the light will come on when. Turn the ignition to run (one position before starting engine).

How to reset the MAINT REQD light on a Toyota DIY from

For toyota tacoma years 2006, 2007,2008 models the oil reset maintenance light system can also be reset as follows: If it does not, press down the ‘reset’ or ‘trip’ button until the reading on the odometer displays ‘trip a’. Press and hold odo/trip button and turn ignition to the “run” position.

After Performing The Oil Change The Maintenance Data Will Need To Be Reset.

The maintenance light should start to flash, and you may hear a beeping sound. Follow these few simple steps to reset maintenance light toyota that is not a camry or prius: Push and hold the dashboard odometer button and turn the key to position two.

You Might Even Hear Beeping Noises.

The check engine light on your 2013 toyota tacoma will usually shut itself off if the issue or code that caused it to turn on is fixed. Turn the ignition to run (one position before starting engine). Toyota tacoma reset maint reqd light indicator.

See also  How To Reset Maintenance Light On Toyota Corolla 2007

Go To The Odometer And Press The Odometer To The “Trip A” Position, Then Turn The Key “Off”.

Continue pressing on the trip odometer reset knob until the odometer indicates 0000000 and the maintenance light goes off. Turn the key “on” and hold the odometer button until it flashes all zeros. Push and hold the trip meter reset button on the dashboard, then turn your key to the second position.

On Your 2013 Toyota Tacoma, To Reset The Maintenance Light, First Put Your Key In And Turn It To The “On” Position.

After performing the oil change the maintenance data will need to be reset. If you see the light still on, repeat the process. The odometer should read ‘trip a’.

Push And Hold The Trip Reset Or Mode Button.

While holding reset button, switch ignition to on position. Continue to hold down the trip odometer reset button until “000000” miles appears on the display and the maintenance light turns off. Press the odo/trip button to display to trip a.