How To Turn On Water Heater Pilot Light

How To Turn On Water Heater Pilot Light. Now off the regulator valve. Use a flashlight or a headlamp to find the burner inside.

Autumn Walk Emerson Water Heater Pilot Light from www.autumnwalk.com

To turn on the pilot, continue pressing the red button until the piezo igniter strikers appear close to the gas knob. If your bradford white water heater is not igniting, you first need to remove your cover plate. You can also switch it by pressing down the red button left.

But First, Check For A Gas Leak.

As long as you hold the pilot button down for a minimum of 30 seconds before releasing it, you will hear the pilot’s sound. This water heater part detects the pilot’s flame which then causes the gas valve to open. Retrace your steps up the pipe until you reach an intake valve.

If There’s A Leak, Then Igniting A Flame Can Cause An Explosion.

This will start the flow of gas so you can light the flame. 1 steps to reignite water heater. Find the gas regulator valve and turn it to the “off” position.

See also  How To Detect A Gas Leak From Water Heater

This Is Where We Can Move On And Check The Interior Door Panel For The Directions To Find Out How To Turn On Gas Water Heater Pilot Light.

I believe that the design is to get you to stop at the pilot setting to get the pilot lit before advancing the knob to on. Your status light on your control panel above the cover plate should be blinking frequently. If the water heater has a manual “ignite” button, press that to light the pilot.

To Turn The Water Heater Pilot Light Off, Set The Heater To The Lowest Temperature Possible.

To turn your pilot light on, turn the red dial on your control panel down to pilot. Allow ten minutes for the remaining oil or gas to be cleared from the control module. Then switch the button on the heater to the off position.

The Gas Intake Pipe Is Directly Connected To The Water Heater’s Base.

A pilot light that won’t stay lit quickly turns your once functioning water heater into a useless piece of equipment that just takes up space. Turn the gas knob to “pilot,” press and hold it down. Locate the dial first on the side of the water heater, and spin it clockwise to reduce the temperature until it is as low as possible.